Excess harness should NEVER be rolled up and tucked behind the seat as in the image right. This can cause to pulling and tearing of the wires if caught in objects falling behind the seat (see Figures below).
The harness should be run from the Seat and Buckle, with the harness tucked behind left-hand side panel, and excess slack harness should be stored under the dash in front of vehicle. Figure below shows the harness connectors in the protection case and the harness tucked and running along existing paths into the side panel.
To connect the buckle wiring, plug the supplied black 3-pin connector into the OEM 3-pin buckle connector. The buckle wiring must be connected with Red going to C, Green/White going to B, and Black going to A.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article